drivers/phy/socionext/phy-uniphier-usb3hs.c · v5.14-rc1 · Dennis Giaya / linux · GitLab

Two Factor Authentication (2FA) as been enabled for all git.whoi.edu users. For instructions on how to set up 2FA, follow the instructions on this page, or click here for a step-by-step walk-through.

Once you have 2FA setup, you may need to create an Access Token to pull and push with git. You will not be able to authenticate with git using your password once you enable 2FA. See this link for how to set up and use a Personal Access Token.

The decision to enable 2FA for all users is for added security. Oct 30th, some users experienced account lockout due to bad actors. 2FA will help prevent such incidents in the future. Thank you.

Jan 30, 2020

phy: uniphier-usb3hs: Change Rx sync mode to avoid communication failure · 25858c52

Kunihiko Hayashi authored Jan 30, 2020

In case of using default parameters, communication failure might occur
in rare cases. This sets Rx sync mode parameter to avoid the issue.

Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>

25858c52

phy: uniphier-usb3hs: Change Rx sync mode to avoid communication failure

Kunihiko Hayashi authored Jan 30, 2020

In case of using default parameters, communication failure might occur
in rare cases. This sets Rx sync mode parameter to avoid the issue.

Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>